The Silca Tubeless Valve Kit w/Speed Shield is the highest quality for reduced weight, improved aerodynamics and more robust tubeless conversions, especially with carbon and deep section wheels.

Silca Tubeless valve stems are designed to strike a balance between weight, strength, airflow and ease of installation. 

For Tubeless Valve Stems, Silca have chosen to keep the geometry of the finest brass valve stems, while producing them from the finest cold drawn aluminum bar rather than a hollow extruded bar.  This process is less cost effective than extrusion, but allows for a higher material yield strength and more accurate machined parts.  As a result, Silca's valves weigh less than half of brass valve stems, yet are 50-200% stronger than common lightweight aluminum valve stems.  

Silca's paired these valves with the finest, fully CNC machined valve cores you can buy.  Just looking at them, you can see the quality, from the fully machined brass pin with roll formed thread, to the spin-formed ridge (instead of crimped) that keeps the valve nut from unthreading too far.  The fully machined design leaves more internal space within these valves allows for better airflow as well as making them more tolerant of sealant.

Perhaps the most exciting feature of the Silca tubeless program is the Speed Shield. The concept grew out of an initial study Silca did on ways of improving aerodynamics around the valve stem, which proved out that 'shielding' the valve stem could save about 0.15-0.20 watts of energy per 10mm of valve stem encased in the shield.  Of course you cannot shield the whole stem, but they looked at this a second time in regards to tubeless and found that shielding the lower 10mm of the stem AND the nut resulted in even greater savings, 0.2-0.3 Watts per wheel at 30mph.  Each Speed Shield contains a spherical recess to hold the valve stem nut, and the high durometer, high strength silicone is optimized to ensure the valve stem maintains optimal tension within the rim so that it remains sealed, but also ensures there are no bending loads in the stem which are the cause of so many failures in aluminum stems.  


Less than half the weight of brass valve stems

50-200% Stronger than typical aluminum valve stems

Ultimate level, fully machined brass valve cores with improved airflow

SpeedShield Improves wheel aerodynamics while protecting carbon rims

Spherical nut eliminates bending forces on valve stem for improved strength

Available 44, 60 and 80mm lengths
What's in the Kit?

Valve Stems x2

Spherical Valve Nuts x2

SpeedShield Rim Protectors x2

Be The First To Review This Product!

Help other Bikebug Pty Ltd users shop smarter by writing reviews for products you have purchased.

Write a product review