Silca Synerg-E Wet eBike Lube

The Ultimate Wear Reducing Lubricant for eBikes
Based on the award-winning Synergetic lubricant, the first and only wet lube to record a 0.0% wear block in Zero Friction Cycling lab testing, Synerg-E takes SILCA's patent pending Tungsten Tribofilm Technology and blends it into a higher viscosity lubricant (Silca Synerg-E Wet eBike Lube) optimised for the high torque experienced in eBike drivetrains.

Contains NO PFAS Or Other Fluorinated Chemicals
eBike chains experience more than 2X the internal pressures of the traditional bike chain and are capable of wearing out expensive drivetrain components like chains, chainrings, and cassettes at more than twice the rate of traditional bicycles. By increasing viscosity and adding Calcium Sulfonate to the mix, Synerg-E gives up roughly 1 watt of pure efficiency to Synergetic, while nearly doubling the oil film strength to ensure the lowest rates of chain and drivetrain wear of any lubricant currently available. As with all SILCA lubricants, Synerg-E uses only the finest, environmentally-friendly pure synthetic base oils with additives approved as safe by the EPA and Bureau of Land Management. Synerg-E contains NO PFAS or other Fluorinated chemicals.

Eventually Displaces Factory Grease On All Common Chain Brands
Synerg-E will work best on a perfectly clean/dry chain, but this is not absolutely necessary. It will eventually displace factory grease on all common chain brands if dripped over top on a new chain. The chain should be free of dirt and contaminants before applying Synergetic.

Initial Application On Clean/Dry Chain
Apply 1 drop of Synerg-E to each set of gaps on each roller (2 drops per roller).
Cycle chain backwards 10-12 revolutions to allow lubricant to fully penetrate.
Wipe Outside of chain and chainrings as dry as possible using a MicroFibre cloth.
Re-apply 1 drop per roller every 500-750 km or after every wet/rainy ride.